Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of BESTNYL SE25VI02A - PA66-GF25 - Grupo Triesa

Material Data Center offers the following functions for BESTNYL SE25VI02A:
unit conversion, PDF datasheet print, comparison with other plastics, snap fit calculation, beam deflection calculation, CAE Interfaces

Check here, which other Bestnyl datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Propiedades mecánicas - Propiedades térmicas - Propiedades eléctricas - Otras propiedades
Any use of this information falls under the rules of our disclaimer.
Propiedades mecánicasSeco / CondUnidadesMétodo de ensayo
ISO Data
Módulo de tracción 8000 / 5900 MPa ISO 527
Esfuerzo de tracción 145 / 105 MPa ISO 527
Alargamiento a rotura 3 / 4 % ISO 527
Resistencia al impacto Charpy, +23°C 55 / 85 kJ/m² ISO 179/1eU
Resistencia al impacto Charpy c/entalla, +23°C 7 / 11 kJ/m² ISO 179/1eA
Propiedades térmicasSeco / CondUnidadesMétodo de ensayo
ISO Data
Estabilidad al calor, 0.45 MPa 250 / * °C ISO 75-1/-2
Combustibilidad a espesor h HB / * class IEC 60695-11-10
Propiedades eléctricasSeco / CondUnidadesMétodo de ensayo
ISO Data
Resistividad superficial específica * / 1E13 Ohm IEC 62631-3-2
Resistencia dieléctrica 32 / 28 kV/mm IEC 60243-1
Indice comparativo de linea de fuga 450 / - - IEC 60112
Otras propiedadesSeco / CondUnidadesMétodo de ensayo
Absorción de agua 0.9 / * % Sim. to ISO 62
Densidad 1320 / - kg/m³ ISO 1183
Características
Procesamiento y forma de entrega
Moldeo por inyección
Forma de suministro
Sémola, Negro
Aditivos
Lubricante
Disponibilidad regional
Europa
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.