Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of Bergaflex® BFI 35A-322 - TPS - Avient Corporation

Material Data Center offers the following functions for Bergaflex® BFI 35A-322:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other Bergaflex datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Propriétés mécaniques - Propriétés diverses - Préparation et conditionnement des éprouvettes
Any use of this information falls under the rules of our disclaimer.
Informations produit
Limited resistance. Considerable dimensional changes, and possibly
irreversible changes in properties after prolonged contact. Consultation
advisable before use.

Please consider the information about the application of the materials.
Propriétés mécaniquesValeurUnitéNorme du test
ISO Data
Contrainte à 100% de déformation 0.8 MPa ISO 527
Contrainte à 300% de déformation 1.5 MPa ISO 527
Contrainte à la rupture TPE 4.5 MPa ISO 527
Déformation à la rupture TPE >300 % ISO 527
Déformation rémanente en compression à 23 °C, 24h 16 % ISO 815
Déformation rémanente en compression à 70 °C, 24h 47 % ISO 815
Déformation rémanente en compression à 100 °C, 24h 80 % ISO 815
Dureté Shore A 35 - ISO 7619-1
Propriétés diversesValeurUnitéNorme du test
Masse volumique 1180 kg/m³ ISO 1183
Préparation et conditionnement des éprouvettesValeurUnitéNorme du test
ISO Data
Injection, température de la matière fondue 170 °C ISO 294
Injection, température du moule 30 °C ISO 294
Caractéristiques
Transformation
Moulage par injection, Extrusion de films, Extrusion de profilés, Extrusion (autres), Soufflage, Calandrage
Conditionnement
Granulés
Propriétés spéciales
Stabilisé aux intempéries
Disponibilité régionale
Europe
Conditions générales
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.