Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of Rilsamid® AMNO - PA12 - ARKEMA

Material Data Center offers the following functions for Rilsamid® AMNO:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other Rilsamid datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Any use of this information falls under the rules of our disclaimer.
Testo del prodotto
Rilsamid® AMNO resin is a natural polyamide 12. This grade is designed for injection moulding.
Caratteristiche Fisichesecco/condUnitáNorma del test
ISO Data
Indice di fusione di volume, MVR 57 / * cm³/10min ISO 1133
Temperatura 235 / * °C -
Carico 2.16 / * kg -
Proprietà Meccanichesecco/condUnitáNorma del test
ISO Data
Modulo a trazione - / 1100 MPa ISO 527
Carico unitario a trazione - / 37 MPa ISO 527
Deformazione a snervamento - / 8 % ISO 527
Deformazione nominale a rottura - / >50 % ISO 527
Resistenzia all'urto Charpy con intaglio, +23°C - / 5 kJ/m² ISO 179/1eA
Resistenzia all'urto Charpy con intaglio, -30°C - / 6 kJ/m² ISO 179/1eA
Proprietà Termichesecco/condUnitáNorma del test
ISO Data
Temperatura di fusione, 10°C/min 180 / * °C ISO 11357-1/-3
Altre Proprietàsecco/condUnitáNorma del test
Massa volumica 1010 / - kg/m³ ISO 1183
Caratteristiche
Processabilità e Forma di Forni
Stampaggio ad Iniezione
Forma fisica disponibile
Pellet
Disponibilità geografica
Altre informazioni
Stampaggio ad Iniezione

Processing conditions, Injection:

- Typical melt temperature (Min / Recommended / Max) : 230°C / 270°C / 280°C.
- Mold temperature : 25 - 60°C
- Drying time and temperature (only necessary for bags opened for more than two hours) : 4-6 hours at 80 - 90°C.
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.