Complete Set of CAMPUS® Data, ASTM Data, Biopolymer Database, Application Database, Tradename Database, Literature Database, Toolbox.

Material datasheets available free. Online registration at: www.materialdatacenter.com

Material Data Center is a leading international information system for the plastics industry. Material Data Center offers a comprehensive plastics database, calculation tools, CAE interfaces, a literature database and an application database. For more information about Material Data Center visit www.materialdatacenter.com.

This is the free Material Data Center Datasheet of HOPELEN J-170H - PP - Lotte Chemical Corporation

Material Data Center offers the following functions for HOPELEN J-170H:
unit conversion, PDF datasheet print, comparison with other plastics

Check here, which other Hopelen datasheets, application examples or technical articles are available in Material Data Center

Use the following short links to get directly to the properties of interest in this datasheet:
Características de processamento/físicas - Propriedades mecânicas - Propriedades térmicas - Outras propriedades
Any use of this information falls under the rules of our disclaimer.
Características de processamento/físicasValorUnidadeMétodo de ensaio
ISO Dados
Índice de fluidez, MFI 30 g/10min ISO 1133
ASTM Dados
Índice de fluidez, MFI 30 g/10min ASTM D 1238
Propriedades mecânicasValorUnidadeMétodo de ensaio
ISO Dados
Tensão no escoamento 33 MPa ISO 527
Deformação na ruptura 100 % ISO 527
Módulo de flexão, 23°C 1320 MPa ISO 178
ASTM Dados
Resistência à tração no escoamento 35 MPa ASTM D 638
Deformação na ruptura 100 % ASTM D 638
Módulo de flexão 1670 MPa ASTM D 790
Impacto Izod com entalhe, 1/8 in 29 J/m ASTM D 256
Impacto Izod com entalhe, baixa temperatura 20 J/m ASTM D 256
Temperatura -10 °C -
Propriedades térmicasValorUnidadeMétodo de ensaio
ISO Dados
Temperatura de deflexão térmica , 0.45 MPa 95 °C ISO 75-1/-2
ASTM Dados
DTUL @ 66 psi 115 °C ASTM D 648
Outras propriedadesValorUnidadeMétodo de ensaio
Densidade 900 kg/m³ ISO 1183
Densidade 900 kg/m³ ASTM D 792
Características
Processamento
Moldagem por injeção
Características especiais
Estável contra o calor
Características
High Gloss, Resistente a riscos, Homopolímero
Aplicaciones
Brinquedos
Disponibilidade regional
América do Norte, Europa, Ásia Pacífico
Disclaimer
Copyright Altair Engineering GmbH. Altair Engineering GmbH assumes no liability for the system to be free of errors. The user takes sole responsibility for the use of this data under the exclusion of every liability from Altair Engineering GmbH; this is especially valid for claims of compensation resulting from consequential damages. Altair explicitly points out that any decision about the application of materials must be double checked with the producer of this material. This includes all contents of this system. Copyright laws are applicable for the content of this system.
Created: Source: www.materialdatacenter.com


Material Data Center is provided by M-Base Engineering + Software GmbH. M-Base Engineering + Software GmbH assumes no liability for the system to be free of errors. Any decision about the application of materials must be double checked with the producer of this material.

Additional information about this material, like producer contact address, etc. can be found at www.materialdatacenter.com. For access to this extra information a registration is requested. Free online registration is available.