This is the free Material Data Center Datasheet of Ultraform® W2320 0035 LEV AT - POM - BASF

非常易于自由流动、 快速固化的等级， 用于加工难度极高但对机械性能要求较低的应用。 含脱模剂。

根据ISO 1043-1: POM的缩写名称
根据ISO 29988-POM-K,,M-GNR,5-2的名称

PREPROCESSING
Pre/Post-processing, max. allowed water content: .1 %
Pre/Post-processing, Pre-drying, Temperature: 100 - 120 °C
Pre/Post-processing, Pre-drying, Time: 3 - 4 h

PROCESSING
injection molding, Melt temperature, range: 190 - 220 °C
injection molding, Melt temperature, recommended: 195 °C
injection molding, Mold temperature, range: 60 - 120 °C
injection molding, Mold temperature, recommended: 90 °C
injection molding, Dwell time, thermoplastics: 10 min

Processing

Usual single-flighted three-section screws with an effective screw length of at least 15 D, better 20 - 23 D are suitable for the injection molding of Ultraform.

Pretreatment

Granules or pellets in original packaging can be processed without any special pretreatment. Granules or pellets which have become moist due to prolonged or incorrect storage (e.g. by formation of condensed water) must be dried in dehumidifying or recirculating air dryers for approx. 3 hours at about 100 - 110 °C. The moisture content should not exceed 0.2 %.


Postprocessing

If parts were produced at a comparatively low mold temperature (e.g. in order to obtain short cycle times) and must not change their geometry in use thermal postprocessing inducing dimensional changes by postcrystallization may be necessary. In such cases parts should be stored in an oven with recirculated air at temperatures of 100 - 130 °C until dimensions don't change significantly any further. The time needed for this has to be determined experimentally.